10 possible reasons behind “refrigerator not cooling”

On a hot afternoon, you open your refrigerator in a hope to enjoy a glass of chilled juice. But you find that your refrigerator not cooling. What an unpleasant moment! Here are 10 possible reasons behind “why is your refrigerator not cooling enough or not cooling at all”:

1. Frosted evaporator coil

There are evaporator coils and circulating fan in the freezer zone of the refrigerator. Poor cooling can be a result of excessive frost development on the evaporating coils. Over time frost accumulates over the coils and fan. When frost gets accumulated over the evaporator coils, they get insulated. Due to this, the circulating fan is unable to draw air over the frosted coils. There may still be a small amount of cooling because of the frost over the coils, but with no air flow over the coils.This frost should be removed by manual defrosting or automatic defrost (in frost-free refrigerators) for proper cooling inside the refrigerator.

2. Faulty evaporator fan 

The fan circulates the cool air from the freezer to other compartments inside the refrigerator. When evaporator fan stops working it cannot circulate cool air inside the food section. Due to which the freezer continues to be cold but food section does not get cool.

3. Out of order defrost system

In any frost-free refrigerator, there is a defrost system which controls the cooling and defrosts cycle. The components of the defrost system are: a defrost timer and a defrost heater:

defrost timer switches the refrigerator between the cooling and defrosts mode. If it goes bad and stops at cooling mode, it causes excessive frost to build up on the evaporator coils which reduces the air flow. Or when it stops at the defrost mode it melts all the frost and does not go back to the cooling cycle.

defrost heater melts the frost developed over the evaporator coil. But if it goes bad then excessive frost accumulates on coils reducing the cool air flow inside the refrigerator.

So when either of the 2 becomes faulty, the refrigerator does not understand when to cool and when to defrost.

4. Faulty compressor 

A compressor is the heart of the refrigeration cycle. When it does not work properly then the entire cooling process does not even start. The job of the compressor is to compress the refrigerant from a low-pressure cool vapor into high-pressure hot vapors. This compressed refrigerant in the form of hot high-pressure vapors then flows through the condenser where it gets condensed into high-pressure liquid. This liquid then flows through the evaporator coil where it evaporates and cools down to a low-pressure vapor. Air flows over the cooling coils and keeps the refrigerator cool. So when the compressor is out of order, this refrigeration cycle does not even start.

5. Insufficient refrigerant level

If the compressor is the heart, the refrigerant is the blood of the cooling cycle. Refrigerant leakage or under limit refrigerant also effects the cooling inside the refrigerator.

6. Dirt insulated condenser coils

When high-pressure hot refrigerant condenses in the condenser, lot of heat is dissipated during this conversion. But when the condenser coil is dirty and loaded with debris, heat does not flow out of the coils properly. This heat stays inside the refrigerator and reduces the cooling.

7. Defective condenser fan 

In your refrigerator, there is a condenser fan that forces hot air out of the refrigerator. So when it goes bad the hot air cannot be released into the room and remains inside the refrigerator. Because of this, the temperature inside the refrigerator shoots up. A faulty fan motor or defective fan blades prevent the condenser fan from working properly.

8. Defective start relay

A start relay is a small device located near the compressor. It helps compressor in starting up. If the start relay is defective, then the compressor will not start and so the cooling process in the refrigerator will not commence.

9. Defective start capacitor

There is a start capacitor that gives a boost to the compressor to start up. If this capacitor is burned out, the compressor might not start up and the refrigeration cycle will not commence cooling the refrigerator.

10. Faulty thermistor

A thermistor is a sensor that controls the air temperature inside the refrigerator and controls the start and stop of cooling cycle. If it goes faulty, then the refrigerator does not cool at all or cools continuously.

Refrigerator not cooling” is a very common problem and can be taken care by good refrigerator repair professionals.

by DIVYA MISHRA

Published by wesabiblog

I'm an entrepreneur who believes in using technology to provide solution to humanity;Maybe someday tech might help us live forever!!!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: